燃气发电机常见故障

Common faults of gas generators

1. 启动失败：可能是由于电池电量不足、点火系统故障、燃气供应问题等导致。

1. Start failure: It may be caused by insufficient battery power, ignition system failure, gas supply issues, etc.

2. 燃气发电机功率不足：可能是燃气供应不足、空气滤清器堵塞、涡轮增压器故障等引起的。

2. Insufficient power of gas generator: may be caused by insufficient gas supply, clogged air filter, turbocharger failure, etc.

3. 排放超标：可能是燃烧不完全、燃料质量问题、排放控制装置故障等造成的。

3. Emissions exceeding standards: may be caused by incomplete combustion, fuel quality issues, malfunction of emission control devices, etc.

4. 机械故障：如轴承磨损、齿轮损坏、振动过大等。

4. Mechanical faults: such as bearing wear, gear damage, excessive vibration, etc.

5. 电气故障：如发电机绕组短路、断路、励磁系统故障等。

5. Electrical faults: such as generator winding short circuit, open circuit, excitation system failure, etc.

燃气发电机常见故障的处理方法

Common troubleshooting methods for gas generators

1. 启动失败：检查电池电量，更换电池或充电；检查点火系统，清洗或更换点火电极；检查燃气供应系统，确保燃气供应正常。

1. Startup failure: Check the battery level, replace the battery or charge it; Check the ignition system, clean or replace the ignition electrodes; Check the gas supply system to ensure normal gas supply.

2. 燃气发电机功率不足：检查燃气供应压力和流量，调整或更换燃气阀门；清洁或更换空气滤清器；检查涡轮增压器的工作状态，必要时进行维修或更换。

2. Insufficient power of gas generator: Check the gas supply pressure and flow rate, adjust or replace the gas valve; Clean or replace the air filter; Check the working status of the turbocharger and repair or replace it if necessary.

3. 燃气发电机排放超标：检查燃烧室、喷油嘴和火花塞的清洁情况，进行清洗或更换；检查燃料质量，使用合格燃料；检查排放控制装置

3. Gas generator emissions exceeding standards: Check the cleanliness of the combustion chamber, fuel injectors, and spark plugs, and clean or replace them; Check the quality of fuel and use qualified fuel; Check emission control devices

4. 机械故障：对轴承进行润滑或更换；修理或更换损坏的齿轮；检查机组安装基础，确保其平稳、牢固。

4. Mechanical failure: Lubrication or replacement of bearings; Repair or replace damaged gears; Check the installation foundation of the unit to ensure its stability and firmness.

5. 电气故障：检查发电机绕组绝缘情况，进行绝缘处理或更换绕组；检查励磁系统，修理或更换故障部件。

5. Electrical fault: Check the insulation condition of the generator winding, perform insulation treatment or replace the winding; Check the excitation system, repair or replace faulty components.

本文由燃气发电机组配件友情奉献.更多有关的知识请点击:https://www.huannengpower.cn 真诚的态度.为您提供为全面的服务.更多有关的知识我们将会陆续向大家奉献.敬请期待.

This article is a friendly contribution from the accessories of gas generator sets. For more related knowledge, please click: https://www.huannengpower.cn Sincere attitude. We will provide you with comprehensive service. We will gradually contribute more relevant knowledge to everyone. Stay tuned