As an important standby power supply, diesel generator set is very important. If it is the standby generator of the unit, how to store and keep the generator set?

一、短期内不使用时的存放与保管方法：

1、 Storage and safekeeping methods when not in use in a short term:

1、放净燃油

1. Drain the fuel

2、将发动机的活塞转至压缩的上止点上

2. Turn the piston of the engine to the top dead center of compression

3、移入室内存放，并用罩布盖好，不能放置于潮湿的地方，不要与易燃、易爆及腐蚀性物品放在一起，并且要定期转动曲轴

3. Move it into the room for storage and cover it with a cover cloth. It cannot be placed in a wet place. It should not be placed with inflammable, explosive and corrosive articles, and the crankshaft should be rotated regularly

二、长期内不使用时的存放与保管方法：

2、 Storage and safekeeping methods when not in use for a long time:

1、按短期内不使用的方法进行操作

1. Operate according to the method not used in the short term

2、清理干净机组表面层的赃物，用压缩空气将机组内部吹干净，发电机里面放满干燥剂，用厚纸将发电机端盖上，并且将所有通风口盖好，并用绳子固定好。

2. Clean the dirt on the surface layer of the unit, blow the inside of the unit with compressed air, fill the generator with desiccant, cover the generator end with thick paper, cover all ventilation openings and fix them with ropes.

3、将机滤、空滤等部件中的机油放净

3. Drain the oil in the machine filter, air filter and other components

4、从排气歧管向每个气缸注入100~200g机油，将曲轴转动数十次，以便机油在气缸内均匀分布，并使活塞处于压缩上止点上

4. Inject 100 ~ 200g of engine oil into each cylinder from the exhaust manifold and rotate the crankshaft dozens of times so that the engine oil is evenly distributed in the cylinder and the piston is at the top dead center of compression

5、取下气门室盖，用脱水机油润滑气门的结构

5. Remove the valve cover and lubricate the valve structure with dehydrated engine oil

6、将排气口、空滤、燃油箱通气孔、低温启动装置的排烟口等用油纸进行包封；

6. Seal the exhaust port, air filter, fuel tank vent and smoke exhaust port of low-temperature starting device with oil paper;

7、将柴油机、发电机、联轴口、底架及发电机所有部件、工具、附件等金属表面先用洗洁剂擦洗干净，必要的地方可以涂上黄油

7. Clean the metal surfaces of diesel engine, generator, coupling port, underframe and all parts, tools and accessories of generator with detergent, and apply butter where necessary

8、每月摇转曲轴1~2次，每次摇转后均应使活塞处于压缩上止点上。

8. Crank the crankshaft 1 ~ 2 times a month, and make the piston at the compression top dead center after each crank.

以上就是为大家介绍的有关焦化气发电机组的详细介绍,希望对您有所帮助.如果您有什么疑问的话,欢迎联系我们.我们将以专业的态度,为您提供服务https://www.huannengpower.cn

The above is the detailed introduction of coking gas generator set. I hope it will be helpful to you If you have any questions, please contact us We will provide you with professional service https://www.huannengpower.cn