The natural gas generator set has good power generation quality, fast start-up, stable operation and many advantages. But this also needs to pay attention to some matters when using. For example, startup and shutdown of the unit. The small editor introduced that the startup and shutdown of natural gas generator set should be done one by one, and the steps should be clear!

一、天然气发电机组在开机前要注意燃气管系、燃气部件的安装、传感器与控制屏组合模拟检测等事项。接下来的机组来及事项要注意：

1、 Before starting the natural gas generator set, pay attention to the installation of gas pipeline system and gas components, combined simulation detection of sensor and control panel, etc. Notes for the next unit:

1、开机前，应清理机组（旋转部件）上放置的杂物（如盘车杠、工具、螺钉等），以免开车时工件飞出去伤人。

1. Before start-up, the sundries (such as turning bar, tools, screws, etc.) placed on the unit (rotating parts) shall be cleaned to prevent the workpiece from flying out and hurting people during start-up.

2、开机前手动盘车时，注意先断开起动电源，以免误触动起动按钮，盘车杠飞出去伤人。

2. When turning manually before startup, pay attention to disconnect the starting power supply first, so as not to touch the start button by mistake, and the turning rod will fly out and hurt people.

二、天然气发电机组运行要求

2、 Operation requirements of natural gas generator set

1、启动时，先踏下脚踏开关，按下启动按钮，将缸内燃气排空后再开启燃气阀门，严禁先给燃气再按启动按钮。启动不成功或启动后又熄火时，应关闭燃气阀门，查清原因，排净缸内混合气体后，再按规定程序重新启动。启动成功后，应踢开脚踏开关。

1. When starting, first step on the foot switch, press the start button, empty the gas in the cylinder, and then open the gas valve. It is strictly prohibited to supply gas first and then press the start button. In case of unsuccessful startup or flameout after startup, close the gas valve, find out the cause, exhaust the mixed gas in the cylinder, and then restart according to the specified procedures. After successful startup, kick off the foot switch.

2、开机时，打开门窗，开动排风装置，直到停机。

2. When starting up, open the doors and windows and start the exhaust device until it stops.

3、.操作者在机房内操作时，应戴安全帽或头盔，机器运转过程中不能直接面对防爆门，应避开飞轮等高速旋转件，不能触摸排气管等高温件。

3、. When operating in the machine room, the operator shall wear safety helmet or helmet. During the operation of the machine, the operator shall not directly face the explosion-proof door, avoid high-speed rotating parts such as flywheel, and shall not touch high-temperature parts such as exhaust pipe.

4、运行中，若发现燃气有泄漏情况，操作人员应卸掉负荷并停机检查。

4. In case of gas leakage during operation, the operator shall unload the load and stop the machine for inspection.

5、机组运行时，注意燃气发动机防爆安全门，一旦爆破（其声音较大）应关闭气源，换防爆胶皮后方可重新启动。

5. When the unit is running, pay attention to the explosion-proof safety door of the gas engine. In case of explosion (with loud sound), close the air source and replace the explosion-proof rubber before restarting.

三、天然气发电机组停机应采取的措施

3、 Measures to be taken for shutdown of natural gas generator unit

1、正常停机时，应先使机组在怠速运转至水温、油温降到60℃以下后再切断气源停机。

1. During normal shutdown, make the unit operate at idle speed until the water temperature and oil temperature drop below 60 ℃, and then cut off the air source for shutdown.

2、紧急停机后，应“盘车、泵油”至水温、油温降到60℃以下后再切断气源停机。

2. After emergency shutdown, turn the gear and pump oil until the water temperature and oil temperature drop below 60 ℃, and then cut off the air source for shutdown.

3、停机后，应将“电磁阀电源”开关置于“关（OFF）”位置，并关闭燃气总阀门。

3. After shutdown, turn the "solenoid valve power" switch to the "off" position and close the main gas valve.

以上就是为大家介绍的有关天然气发电机组的详细介绍,希望对您有所帮助.如果您有什么疑问的话,欢迎联系我们.我们将以专业的态度,为您提供服务https://www.huannengpower.cn

The above is the detailed introduction of natural gas generator set. I hope it will be helpful to you If you have any questions, please contact us We will provide you with professional service https://www.huannengpower.cn